ISPGDX160VA-9B272I

ISPGDX160VA-9B272I FPGAs Overview

The ispGDXV/VA architecture provides a family of fast, flexible programmable devices to address a variety of system-level digital signal routing and interface requirements including:

• Wide Data and Address Bus Multiplexing (e.g. 16:1 High-Speed Bus MUX)

• Programmable Control Signal Routing (e.g. Interrupts, DMAREQs, etc.)

• Board-Level PCB Signal Routing for Prototyping or Programmable Bus Interfaces

The devices feature fast operation, with input-to-output signal delays (Tpd) of 3.5ns and clock-to-output delays of 3.5ns.

The architecture of the devices consists of a series of programmable I/O cells interconnected by a Global Routing Pool (GRP). All I/O pin inputs enter the GRP directly or are registered or latched so they can be routed to the required I/O outputs. I/O pin inputs are defined as four sets (A,B,C,D) which have access to the four MUX inputs found in each I/O cell. Each output has individual, programmable I/O tri-state control (OE), output latch clock (CLK), clock enable (CLKEN), and two multiplexer control (MUX0 and MUX1) inputs. Polarity for these signals is programmable for each I/O cell. The MUX0 and MUX1 inputs control a fast 4:1 MUX, allowing dynamic selection of up to four signal sources for a given output. A wider 16:1 MUX can be implemented with the MUX expander feature of each I/O and a propagation delay increase of 2.0ns. OE, CLK, CLKEN, and MUX0 and MUX1 inputs can be driven directly from selected sets of I/O pins. Optional dedicated clock input pins give minimum clockto-output delays. CLK and CLKEN share the same set of I/O pins. CLKEN disables the register clock when CLKEN = 0.

The Lattice Analog and Digital Crosspoint IC series ISPGDX160VA-9B272I is Analog and Digital Crosspoint IC PROGRAMMABLE GEN DIG CROSSPOINT, View Substitutes & Alternatives along with datasheets, stock, pricing from Authorized Distributors at bitfoic.com, and you can also search for other FPGAs products.

Features

• IN-SYSTEM PROGRAMMABLE GENERIC DIGITAL CROSSPOINT FAMILY

— Advanced Architecture Addresses Programmable PCB Interconnect, Bus Interface Integration and Jumper/Switch Replacement

— “Any Input to Any Output” Routing

— Fixed HIGH or LOW Output Option for Jumper/DIP Switch Emulation

— Space-Saving PQFP and BGA Packaging

— Dedicated IEEE 1149.1-Compliant Boundary Scan Test

• HIGH PERFORMANCE E2CMOS TECHNOLOGY

— 3.3V Core Power Supply

— 3.5ns Input-to-Output/3.5ns Clock-to-Output Delay*

— 250MHz Maximum Clock Frequency*

— TTL/3.3V/2.5V Compatible Input Thresholds and Output Levels (Individually Programmable)*

— Low-Power: 16.5mA Quiescent Icc*

— 24mA IOL Drive with Programmable Slew Rate Control Option

— PCI Compatible Drive Capability*